KNX PIR motion detectors with luminosity sensor.
CEILING-MOUNTED KNX MOVEMENT DETECTOR – DM KNT 001
The lux level and time delay can be set with the control knobs, by using the IR remote control (EM MAN DM0) or via ETS.
One PIR sensor and a high resolution lens can detect the smallest movement.
Depending on the parameterization by ETS, this detectors can work as:
Motion detection: depending on the movement and the daylight.
Twilight switch: teach-in brightness threshold for daylight-dependent switching.
Constant light control: with dimming telegrams.
Signal monitoring: motion detection without brightness sensor.
Brightness sensor: light sensor without motion detection.
Temperature sensor: sends the temperature value.
Detection area of 360º and maximum 7m at 2.5m high.
Flush ceiling mounted.
Power supplied by the Bus.
Programation by ETS3 or later version.
| Product reference | DM KNT 001 |
| Power Supply (V) | 21Vcc – 32Vcc |
| Consumption | 9,3mA |
| Output channels | 1 |
| Maximum Number of Equipments | 0 |
| Detecting angle (º) | 360 |
| Mounting height (m) | 2.5 |
| Coverage diameter (m) | 7 |
| Programming by | ETS3 or later |
| Start up | System Mode |
| Minimum Time setting (seconds) | 0,1 |
| Maximum Time setting (minutes) | 85 |
| Minimum Brightness level (lux) (min) | 5 |
| Maximum Brightness level (lux) (max) | 1000 |
| Tecnology | Infrareds (PIR) |
| Mounting | Flush ceiling |
| Admits contactor | No |
| Zero crossing point | No |
| Compatible with | KNX |
| Minimum Working Temperature (ºC) (min) | -5 |
| Maximum Working Temperature (ºC) (max) | 45 |
| Protection Degree | IP20, Class II |
Related products
