TENSE KNX MOTIVITY PLUS MOTION DETECTOR

 

The KNX Motivity Plus is the surface-mount motion detector for indoor and outdoor use. The KNX Motivity Plus has a very elegant design, no visible lens and is weatherproof.

The KNX Motivity Plus Black contains a motion detector and a temperature sensor, while the KNX Motivity Plus White also has the ability to monitor brightness.

The sensor can be made 100% recessed with the Trimless Wallbox delivered by Xillo®.



KNX MOTIVITY PLUS

POWER SUPPLY: min 21 V DC max 31 V DC supplied by the KNX bus line
MAX POWER CONSUMPTION: 120 mW
CONNECTION TO THE BUS: pluggable terminal
OPERATING TEMPERATURES: -5°C to +45°C
MAX HUMIDITY: 93% relative humidity, no moisture condensation
TYPE OF PROTECTION (EN 60529): IP52 (installed in ceiling)
DIMENSIONS (w x h): 30 x Ø73 mm
SUPPORTED SYSTEMS: KNX
COLOUR: white, black

WHITE KNX Motivity Plus: Motion Detection, Temperature Sensor, registers Brightness
BLACK KNX Motivity Plus: Motion Detection, Temperature Sensor

PROJECTION ZONE
The KNX Motivity Plus detects up until a distance of 12m

TRIMLESS WALLBOX
The sensor is surface mount, but can be made 100% recessed with the Trimless Wallbox delivered by Xillo®. The fixture is in one piece and completely made of the solid patented composite, so no need for an extra mounting kit. Easily install this wallbox in the ceiling or wall thanks to the pre-drilled holes. The unique layered design and the handy indicators for laser positioning, make sure that every fixture is easy to plaster. In addition, the typical Xillo pattern and large mounting surface ensure that the plaster is always perfectly fixated.

KNX MOTIVITY PLUS ANGLE

The Motplus Angle by Tense is a special bracket made for the KNX Motivity Plus sensor.
The minimalistic design of the Motplus Angle is little intrusive in the interior or the exterior. This Motivity Plus accessory tilts the detector 45° downwards. This causes the detection zone to be narrowed and eliminates the blind spot.
PRODUCTION METHOD: 3D printing
COLOUR: white, black
DIMENSIONS: 62,3 x Ø73 mm
TYPE OF PROTECTION (EN 60529): IP20
MATERIAL: PLA (polylactide)

PROJECTION ZONE
The KNX Motivity Plus in combination with the Motivity Angle detects up until a distance of 12m.

FUNCTIONS AVAILABLE:

Infrared movement detector.
Internal temperature sensor with correction.
Internal light sensor which can be corrected through calibration with a photometer. The light sensor of the White KNX Motivity Plus has a light read out value.
Master/Slave mode allows to control the action of the device programmed as master.
Up to four different output actions, which can be independently activated on certain conditions. Possible output actions: switching, dimming, recalling scenes, 1 or 2 Byte unsigned value, up/down, programmable logic ports etc.
Switch-off delay.
Possibility to control the ventilation.
Blocking object.